How to protect home floods

Anyone can be a victim of flooding unless your house is at the top of a mountain. Floods may seriously damage your property. If you do nothing about it, then you will have soacked and smelly carpeting and furniture, damaged electronics, etc. There are some ways by which you can protect your home from floods.

Protecting in house electrical systems

It is advisable to raise your sockets, switches; circuit breakers, etc. at least one foot above the desired level of flood in your neighborhood. Your water heater and furnace must also be placed a foot above your area’s flood level.

Raising your outdoor equipment

The outdoor equipment like air conditioning units, fuel tanks, generators must be placed above the regional flood level. The generators and electrical power units should not be on the ground.

Changing water valves

You should install an exterior or interior backflow valve so that the sewage doesn’t accumulate in your home during flood. Gate valves are recommended as they have stronger seals and. These valves should be set up on all pipes that enter the house.

Find out the path of water flow around your house

Watch out how water accumulates in your house at the time of an average rainstorm. If you find that lot of water accumulates in the street in front of your house during a normal rainstorm, then you should inform your area’s environmental services department. They will be able to give you suggestions on how to prevent accumulation of water.

Wet-proofing your house

You can install foundation vents in your home so that the water can flow throught the building. This will prevent water from being accumulated inside. At least two vents are needed for each wall.

Even after taking all these preventive measures, you can take some last minute preparations also. You can move your furniture and important belonging to a higher place from the ground, turn off the electricity mains supply and clear off any drains so that water can easily flow out.


Suggestions for preventing air conditioner water damage

Air conditioner leaking is a common problem. If you notice water building up in the air conditioning drain pan then you know that there is a problem. Air conditioners normally have a built in drain for collecting water and getting it outside. But if water starts to accumulate then the air conditioner is not functioning properly. In order to avoid such situation, a number of steps can be taken. Here are some tips which can prevent air conditioner water damage Layton:

Regular maintenance of air conditioner

Have a technician regularly visit your house or office to check the air conditioner. The technician will clear the drain line by blowing. As a result, any dirt that may build up will be removed. The technician will also inspect the emergency drain lines to find out if there are any obstructions. They will check the contactor, coils and the refrigerant pressure as well. If any problem is found anywhere, then you need to have your air conditioner serviced immediately.

Changing the filters regularly

It is important to change the filters every month, if possible. This will clear the drain and prevent water from accumulating inside.

Install an overflow shut off device on the drain line

This device turns off the air conditioner when the drain line backs up. This stops overflowing of water from the pan.
Properly installing the cooling system

You should make sure that your cooling system is set up correctly, with drain pans, evavorator coils, etc. You should make sure that the drain lines are inclined at the right angle so that the water may go out easily. Inadequate slope may result in accumulation of extra water in the drain line.

It is better to be cautious and have a regular check of your air conditioner than being faced with a problem that might cost you a lot of money to fix. These tips can help you keep your air conditioner in good shape all the time.